Emulsion

Directions on applying emulsion:

DEGREASE

Using mesh degreaser, work up a lather on both sides of mesh. Flood screen and frame thoroughly with garden type hose, then dry

MIX

Mix emulsion and sensitizer according to instructions on bottle. Let emulsion stand at least two hours before using.

COAT

Fill scoop coater with room temperature emulsion. With the rounded side of the scoop coater, Slowly apply first coat to print side. Then coat squeegee side with first coat . Repeat with the second coat on both sides of the screen withe the same rounded edge of the coater. Finish coating by applying one last coat to the squeegee side of the screen using the straight edge of the scoop coater.

Dry print side down, squeegee side up in drying rack.

If thicker stencil is required, additional coats may be applied to print side after initial drying of stencil. Be sure to dry thoroughly between coats.

DRY

Thoroughly dry screen in horizontal position, print side down, using a dark, clean drying cabinet or screen rack. Temperature should not exceed 104oF (40oC).

EXPOSE

Place emulsion side of photopositive in contact with print side of screen.

DEVELOP

Gently spray both sides of screen with tepid water, wait 30 seconds then gently wash print side of the screen until image is fully open. Rinse both sides thoroughly. Dry screen completely and you are ready to print.